GHRP-6 (5mg)
Table of Contents
Quickstart Highlights
GHRP-6 (5mg) dosage protocol focuses on supporting growth hormone (GH) release for research purposes, often administered multiple times per day via subcutaneous injections.
- Typical daily dose ranges from 100mcg to 300mcg per injection
- Multi-dose daily schedule (2–3x per day) for enhanced GH pulsation
- Reconstitute for practical “units” on a 100-unit insulin syringe
- Store lyophilized in the freezer; reconstituted in the refrigerator
Dosing & Reconstitution Guide
Educational guide for reconstitution and dosing protocol
Standard / Gradual Approach (3 mL = ~1667 mcg/mL)
| WEEK | DAILY DOSAGE | UNITS (mL) PER INJECTION |
|---|---|---|
| Weeks 1–4 | 100 mcg (2× daily) | ~6 units |
| Weeks 5–8 | 150 mcg (2× daily) | ~9 units |
For a 3 mL dilution, each mL contains ~1667 mcg. On a 100-unit insulin syringe, 1 unit ≈ 16.7 mcg. At 100 mcg per injection, this is about 6 units—below the preferred 10 units mark. Note: consider using smaller (50- or 30-unit) insulin syringes if higher accuracy is needed.
- Draw 3.0 mL of bacteriostatic water into a sterile syringe.
- Inject slowly along the vial wall to reduce foaming.
- Gently swirl—avoid vigorous shaking.
- Store the reconstituted solution at 2–8 °C (refrigerator), protected from light.
Advanced / Aggressive Approach (2 mL = 2500 mcg/mL)
| WEEK | DAILY DOSAGE | UNITS (mL) PER INJECTION |
|---|---|---|
| Weeks 1–4 | 100 mcg (3× daily) | ~4 units |
| Weeks 5–8 | 200 mcg (3× daily) | ~8 units |
Reconstitute with 2 mL for a 2500 mcg/mL solution. Each unit on a 100-unit syringe ≈ 25 mcg. Doses of 100 mcg or more will land below 10 units, so smaller insulin syringes are advised for accurate measurement.
- Draw 2.0 mL of bacteriostatic water into a sterile syringe.
- Slowly inject the water to minimize foam.
- Gently roll/swirl—avoid shaking vigorously.
- Store the reconstituted solution at 2–8 °C (refrigerator), protected from light.
Protocol Overview
An overview of daily subcutaneous dosing for GHRP-6.
- Goal : Increase growth hormone release pulses for research applications
- Schedule : 2–3 daily injections for 8 weeks (extend as needed)
- Dose Range : 100 mcg to 300 mcg per injection, based on protocols
- Reconstitution : 2–3 mL for workable “units” on an insulin syringe
- Storage : Lyophilized in freezer; refrigerate once reconstituted
Dosing Protocol
Suggested multi-injection strategy to optimize GH pulsation.
- Daily Dose : Start at 100 mcg per injection
- Frequency : 2–3 subcutaneous injections per day
- Cycle Length : 8 weeks minimum (extend up to 12 weeks if desired)
- Adjustments : Gradually increase to 200–300 mcg if well-tolerated
- Timing : Morning, mid-day, and before bed are common intervals
Storage Instructions
Follow formulation‑specific instructions; do not refrigerate reconstituted tesamorelin.
- Lyophilized : Keep frozen (−20°C) until mixing
- Reconstituted : Refrigerate at 2–8°C and use within 30 days
- Avoid repeated freeze-thaw cycles
Suppilies Needed
Have these items ready for a typical 8–16 week research timeline.
- Peptide Vials :
-
- 8 wks ≈ 2 vials
- 12 wks ≈ 3 vials
- 16 wks ≈ 4 vials
- Insulin Syringes :
-
- 8 wks ≈ 8
- 12 wks ≈ 12
- 16 wks ≈ 16
- Bacteriostatic Water : 1× 30ml
- Alcohol Swabs: 1 box
Important Notes
Practical reminders to maintain safety and consistency.
- Use a fresh, sterile insulin syringe for each injection; rotate injection sites.
- Maintain consistency in dosing schedule to optimize GH pulsation.
- Monitor for any adverse reactions; consult a professional if unsure.
- Track progress over the course of the protocol, adjusting as needed.
How This Works
GHRP-6 (Growth Hormone Releasing Peptide-6) is studied for its ability to stimulate growth hormone release.
- GH Secretion : Binds to ghrelin receptors, aiding in pituitary GH release
- Metabolic Support : May influence appetite and body composition in research models
- Often paired with other GH secretagogues to enhance overall GH output
Potential Benefits & Side Effects
Responses to GHRP-6 can vary based on individual factors and injection frequency.
- May support muscle repair and GH pulsation in research settings
- Some researchers observe changes in appetite regulation
- Possible side effects: temporary hunger increase, mild headaches, or local irritation
- Always discontinue if serious adverse reactions arise
Lifestyle Factors
Ancillary measures that may complement GHRP-6 research.
- Maintain a balanced, protein-rich diet
- Engage in regular exercise; allow adequate recovery
- Manage stress and prioritize sufficient sleep
Injection Technique
Simple guidelines for safe daily injections.
- Clean vial rubber stopper & injection site with alcohol swabs
- Insert needle at a 45–90° angle into subcutaneous tissue
- Inject slowly & rotate sites (abdomen, thigh, etc.)
Recommended Source
We recommend Go Alpha Labs for high-purity BPC-157 + TB-500 blend.
Why Go Alpha Labs?
- Verifies ≥99% purity through independent lab testing
- Trusted by researchers seeking reliable results
- Follows rigorous manufacturing standards for consistent quality
Important Note:
This guide is for educational purposes only. Always consult a qualified healthcare provider before starting or modifying any therapy.
References:
| Source | Link |
|---|---|
| PubMed – GH secretion analysis | View Source |
| PMC – Growth hormone cardiomyopathy study | View Source |
| PMC – IGF-1 in hypogonadal men | View Source |
| Taylor & Francis – Dose-effect and therapy window review | View Source |
| Wiley Online Library – Wound healing and GHRP-6 | View Source |
| University of Maryland – GHRP-6 final summary doc | View Source |
| Taylor & Francis – GH therapy time window abstract | View Source |
| OUP – EJEndo – Endocrinology GH deficiency article | View Source |
| PubMed – HIV-associated GH research | View Source |
| Journal of Endocrinology – Detailed GH mechanism review | View Source |
| WADA – Growth hormone releasing factors doc | View Source |
| OUP – EJEndo – Endocrine Journal PDF | View Source |
| PubMed – GH peptide clinical study | View Source |